Home > Acessories and DIY Repair > Voltage Regulators and BECs
Sort By:
Page of 1
3.0v voltage regulator

This is the voltage regulator that powers your boards MCU.  It is often broken off in a crash and causes the board to be completely inoperative.

Our Price: $1.52
(Out of Stock)
2.7V Voltage Regulator

This is the voltage regulator used to power the board's RX chip.  It is often broken off in a crash and results in a board that will not bind.

Our Price: $1.52
(Out of Stock)
130X BEC NPN Transistor

This is the transistor used as the BEC on the 130X. This part is rated at 30V and 7A. That is well over double the factory installed unit. It is not fail proof in extreme circumstances but it is far better than stock.

There is 1 per board. Price is for 1.

Our Price: $1.75
1 in stock!
Battery Voltage Checker

Quick readout for total voltage then followed by voltage of each cell on the LED screen.
Reverse polarity protection
Weight: 4.7g
Size: 24*19*10(mm)
Voltage range 1-6 cell lipo with 6 channels
Voltage range per channel: 0 to 22 volt
Reverse polarity protection

Our Price: $4.99
17 in stock!
MCPX BL Refresh

This is a complete set of parts to refresh your old MXPC BL 3-in-1. New motor fets to give you that fresh power you used to get. New power wires to help deliver that new fresh power. Also includes new voltage regulators to help with that heating problem.

Kit Includes:
Power Wire
Main Motor Fets(3)
Tail Motor Fets(3)
Voltage Regulator(2)

Our Price: $10.00
1 in stock!
130X Refresh Kit

This is a complete set of parts to refresh your old 130X 3-in-1. New motor fets to give you that fresh power you used to get. New power and main motor wires to help deliver that new fresh power.

Kit Includes:
Power Wire
Motor Wire
Motor P-Fets
Motor N-Fets
BEC
Shrink Wrap

Our Price: $12.00
1 in stock!