Troubleshooting action |
Did the step work? |
Action required if yes |
Did the step work? |
Action required if no. |
Is this a Version 2 board |
Y |
Proceed to step 1 |
N |
Proceed to step 2 |
1. Attempt to bind the board to TX while holding full right rudder during the entire binding process. |
Y |
No action required |
N |
Proceed to step 3 |
2. Attempt to bind board to TX while giving no rudder or aileron commands during the entire binding process |
Y |
No action required |
N |
Proceed to step 3 |
3. If using a computerized TX create a new model from scratch and attempt to bind to that model. If using a non computerized TX attempt to bind to a different TX. |
Y |
Troubleshoot TX/no action required |
N |
Proceed to step 4 |
4. Place the TX antenna an inch or less from the 3 in 1 and attempt to bind |
Y |
Troubleshoot TX or 3 in 1 antenna |
N |
Proceed to step 5 |
5. Place the TX antenna 10' from the 3 in 1 and attempt to bind |
Y |
No action required |
N |
Proceed to step 6 |
6. 3 in 1 board damage likely. Repair 3 in 1 board |
|
|
|